Premium
Category: Power Supply
Different type Adapter, solar penal, lithium ion battery, battery socket, BMS module, etc Scienticy’s best Power Supply parts
Showing 1–16 of 18 results
-
2 Lithium ion battery holder( 18650) with cover and On/Off Switch best quality
₹80.00Add to cart- Holds 2 18650 batteries
- With a cover and Locking
- Comes with an ON/OFF switch
- Easy install, convenient to use
- High-quality plastic material.
- Pre-soldered wire tips
- Cable length: 15cm
- Internal Connection: Series
-
Sale!
3 Series 40A 18650 Lithium Battery Protection Board 11.1V 12.6V with Balance for Drill Motor Lipo Cell Module good quality
₹158.00Add to cart- 3S 11.1V 12.6V 40A 18650 lithium battery protection board (comes with recovery function-AUTO Recovery)
- Application: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650.26650, a polymer lithium battery)
- Continuous discharge current (upper limit): 40A (if the cooling environment is not good, please reduce the load current use)
- Continuous charge current (upper limit): 20A
-
Sale!
3-12v Dynamo Generator motor good quality
₹98.00Read more3-12v Dynamo Generator motor Best generator motor. Very easily generate power. Even you can rotate it by hand it will generate power and can glow a led easily. suitable for wind energy in air turbine, water energy, hand crank energy ,Science fair projects, etc… PRODUCT INFO Generating voltage – 3-12v aprox depending upon speed Generating current …
-
Sale!
9V Battery Connector – Snap-Cap good quality
₹8.00Add to cart9V Battery Connector – Snap-Cap This is 9V Battery Connector Snap. It is used to connect a 9V battery to the required application. This snap power cable to DC 9V clip male line battery adapter for mostly used to power Arduino boards as well as many development boards, DIY science projects,Science fair projects,etc,. The connector …
-
Sale!
Battery Holder for 1.5V AA Battery 2 Cells_best quality
₹25.00Add to cart- Cell Type: AAA (2 cells)
- Holder Type: Open wire holder
- Material: Durable and lightweight plastic
- Connection: Open wire leads for easy connection
- Polarity: Clearly marked positive (+) and negative (-) terminals for correct battery orientation
-
Sale!
Battery Holder for Lithium-Ion 18650 x1 Cell_best quality
₹20.00Add to cartBattery Holder for Lithium-Ion 18650 x 1 Cell This 18650 battery single cell holder is used to carry/store/keep your lithium ion battery in perfect and safe position. It comes with a single mounting hole in the center of plastic case which can help us in mounting it on any surface using screws of 3mm. It …
Battery Holder for Lithium-Ion 18650 x1 Cell_best qualityRead More
-
Sale!
Battery Holder for Lithium-Ion 18650×2 Cell_Best Quality
₹30.00Add to cartBattery Holder for Lithium-Ion 18650X2 Cell This 18650 battery Double cell holder is used to carry/store/keep your lithium ion battery in perfect and safe position. It comes with a Double mounting hole in the center of plastic case which can help us in mounting it on any surface using screws of 3mm. It also have …
Battery Holder for Lithium-Ion 18650×2 Cell_Best QualityRead More
-
Sale!
Digital Multi Servo Tester ESC RC Consistency CCPM Master Speed Control Pack of 1 Good quality
₹135.00Add to cart– Can be easily detected and set the dummy bit server, jitter and median.
– Can be connected to two servos or ESC; MCU control, good stability, high accuracy.
– Turn the knob, steering can be detected.
– If you connect the electronic governor (brush or brushless available), you can get rid of the remote control device for manual control, for testing tone.
– Speed or motor performance is very practical, no longer cumbersome connecting the remote control and the receiver.
– It is equivalent to a “Hand Dynamic Receiver “feature, playing rudder knob analog transmitters. -
Sale!
Good Quality 2600mAh (3C) 3.7 V 18650 Rechargeable Lithium Ion Battery/cell Hongli original
₹178.00Add to cart2600mAh (3C) 3.7 V 18650 Rechargeable Lithium Ion Battery/cell This is a Hongli original 2600mAh (3C) 3.7 V 18650 Rechargeable Lithium Ion Battery/cell . The cell can be charged and discharged up to 3000 cycles without much loss in battery capacity. They are safe to use, environment friendly and have long battery life. It comes …
Good Quality 2600mAh (3C) 3.7 V 18650 Rechargeable Lithium Ion Battery/cell Hongli originalRead More
-
Sale!
Good quality Dmegc INR 18650 Lithium Ion 2600mAh 3.7v Rechargeable battery/Cell
₹198.00Add to cartDmegc INR 18650 Lithium Ion 26E 3.7v Rechargeable battery This is a Dmegc original 2600mAh (3C) 3.7 v INR 18650 Rechargeable Lithium Ion Battery/cell . The cell can be charged and discharged up to 3000 cycles without much loss in battery capacity. They are safe to use, environment friendly and have long battery life. It …
Good quality Dmegc INR 18650 Lithium Ion 2600mAh 3.7v Rechargeable battery/CellRead More
-
Sale!
Mini Solar Panel_6V 0.8W 100mA Good Quality
₹75.00Add to cart6V 0.8W mini Solar Panel This compact 70mm x 70mm Polycrystalline Solar Panel can be used to build portable solar chargers for cellphones and small DC batteries. It can also be used to power small electronic loads like garden lights, staircase lights, or even a small solar toy Science Fair project. Each panel is rated …
-
Sale!
TEC1-12706 12V 92W Thermoelectric Peltier Cooler Module
₹175.00Add to cart- Small module.
- Operable up to 138°C.
- Easy transition between the hot side to the cool side and vice-versa just by reversing the polarity of the supply.
- Quality tested cooling cells.
- Solid-state, vibration-free, noise-free.
- Simple to install and operate.
- Should use with a heat sink.
-
Sale!
TP4056 1A Li-ion Lithium Battery Charging Module With Current Protection – Type C good quality
₹35.00Add to cart- Input interface: Type C
- Current Protection: Yes
- Charging mode: Linear charging.
- Current: 1A adjustable.
- Charge precision: 1.5%.
- Input voltage: 4.5V-5.5V.
- Full charge voltage: 4.2V.
